Issue: Dynamixel Wizard 2.0 not scanning XL330-M288-T on OpenRB-150 Hello Everyone, I have an OpenRB-150 wired with one XL330-M288-T on each of the 4 ports, but when I try and scan for a device on the wizard tool, it does not detect any of the servo motors. I was able to run arduino code from the …

In cases where multiple Dynamixel units are connected but only one is detected, it is often the case that all of the Dynamixel IDs are set to the factory default ID1. If the IDs overlap, only one unit will be detected, so please check that the IDs are different.

Dynamixel Wizard 2.0 not scanning XL330-M288-T

Technical Support

PlatinumAndroid November 27, 2024, 6:08am 7

That was the problem, I was able to set the IDs with this:

Thank you so much!

1 Like